San Jose Navigation GPS Mobile Locator GM-158-USB Manual de usuario descargar pdf (Pagina 8)

www.malags.com

Also connect the power cable to the monitor. Use the standard cable

supplied. See Figure 2.5.

Look for the countersink in the power cable and place it towards the mark

on the connection. Push lightly. If you have it in the correct position it will go

in its position smoothly. To disconnect: Pull out, holding the metal part of

the connection.

Fig. 2.5 Connections on the monitor; to the left, the Ethernet cable and to

the right, the power cable.

Connect the power cable to one of the identical outlets in the battery box

(Figure 2.6). If a RTC is used the power cable is connected to the battery

pack on the RTC, see Chapter Batteries.

2.2.2 Connecting cables to the control unit

Connect Ethernet and power cables to the control unit (Figure 2.6)

Fig. 2.6. The connections to the control unit; left is power and right is

Ethernet communication cable. Above right the connections to the battery

box is seen.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 38 39

Sin comentarios

San Jose Navigation GPS Mobile Locator GM-158-USB Manual de usuario Pagina 8