San Jose Navigation GPS Mobile Locator GM-158-USB Manual de usuario descargar pdf (Pagina 11)

www.malags.com

Fig. 2.10. Backside of the control unit showing one of the two connectors

that should be fitted on the antenna unit.

When the Easy Locator is turned on the control unit will automatically

calibrate to the antenna it is attached to, provided that they are factory

calibrated together. Factory calibration can be done by MALÅ Geoscience

or by your nearest distributor.

Note! Do not switch antennas in the rain. This is important in order to avoid

moisture from reaching vital connectors beneath the control unit. In event

the Easy Locator is operated in the rain or exposed to moisture, it is

extremely important to dry the antenna and control unit before putting the

system away. These precautions will help avoid damages to the system.

2.5 Adjustable wheels

The antenna should be kept parallel with, and as close as possible to the

ground surface. But a higher setting of the antenna may be required when

operating in grass or loose sand etc.

The height of the front and the back pair of wheels should be changed

equally. Pull the spring and turn the adjustment leveller to desired position

(Figure 2.10). This has to be done individually for the front and the back

pair of wheels.

The tires should be inflated to 25 psi (1.7 bar).

Fig. 2.10 Height adjustment spring and adjustment leveller.

When using the RTC the wheels on the RTC are not adjustable, however

the height of the antenna tray can freely be set according to the terrain

conditions.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 38 39

Sin comentarios

San Jose Navigation GPS Mobile Locator GM-158-USB Manual de usuario Pagina 11