San Jose Navigation CT-58 Guía de usuario descargar pdf (Pagina 14)

5.6 Set up Auto Report

Use this command to set up the frequency of Auto Report. If you send the SMS according to the

example shown below to CT-58A, you will have an Auto Report Message every 300 seconds for 99

messages. Once the loop is done, you can send a SMS message to update/renew, or switching off it in

order to renew it.

Note: You may limit the amount of the Auto reply m

essages by inputting the digits from 1 to 9998

in the 「total number of report」

field. When you input 9999, the Auto Report Message will not stop

unless you define a new Auto Report Setting.

Setup format

＃「username」,「Password」,「Function Code」,「intervals (sec)」,「total number of report」＊

Example1：＃username,0000,6,300,99＊

The table 5.6.1 describes the meaning of each segment in the message above.

Table 5.6.1

The table 5.6.2 shows each confirmation message reply after setup

Table 5.6.2

Text Keyed In SMS Description

# Start sign.

username  Default ID of CT-58A.

 If you have changed the Username, please use the updated one.

0000  Default password.

 If you have changed the password, please use the updated one.

6 Mode 6 defines to change the intervals and times of sending-back data

300 A constant interval of sending data

99 The amount of 99 messages sent automatically

* End sign.

Situation Message Reply

Setup Succeeds [username] + Setup OK.Device Auto Report setting is updated.

Setup Fail [username] + Auto Report setting Setup Fail!

Incorrect password [username] + Password setup Fail!

Incorrect username or command

format

[username] + command error

CT-58A is in Emergency Mode

[username] + in emergency, Auto Report setting is

not

allowed.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

Sin comentarios

San Jose Navigation CT-58 Guía de usuario Pagina 14